The video is a tutorial on setting up the H7507 router table extension wing. The presenter begins by explaining that the extension wing has been removed from a table saw and set up on a workbench for clarity. They mention that the table and mounting hardware are designed to accommodate a variety of router base plates, ranging from one quarter to three quarter inches in thickness. The presenter emphasizes the importance of having the correct wrenches and unpacking the included hold downs, which consist of a z-shaped clamp, hold down knob, adjustment bolt, and jam nut.
The hold downs are inserted into the T-slot of the table and positioned to secure the router. The router motor is removed from the housing, and if necessary, the base plate is also removed. Proper orientation of the router base for easy access to the on/off switch is highlighted. The housing is positioned over the center of the table, and the hold downs are slid into place to secure the router. The presenter provides tips for adjusting the hold downs based on the thickness of the router base and avoiding damage to the table edge during tightening.
It's emphasized that a minimum of three hold down clamps should be used, with four being optimal, and they should be positioned on the flat surfaces of the router base. Once the hold downs are tightened securely, the router can be inserted into the base.
We trust you will find this video to be beneficial. Please feel free to reach out to us HERE if you have any questions on how to install your router extension table.