The article provides a guide for setting up the G0774 edge bander, covering adjustments for the infeed fence, striker plate, pressure rollers, edge banding tape, flush trimmers, and panel feeder. It emphasizes following step-by-step instructions and consulting the owner's manual for safety and specific details to ensure proper and safe operation.
This video discusses the setup for the G0774. We've also included the step-by-step instructions below the video so you can follow along.
G0774 Setup Overview
Infeed Fence and Striker Plate
- Adjust the infeed fence to ensure the board is securely positioned.
- Position the striker plate approximately 0.5mm from the spindle.
- Adjust the striker plate using the 10mm bolt and 3mm cap screw.
Pressure Rollers and Edge Banding Tape
- Engage the pressure roller by applying pressure to the board.
- Ensure the board aligns with the infeed fence, striker plate, pressure roller, and secondary roller.
- Insert a small piece of edge banding tape into the infeed stop, rotate the handle towards the tape, and lock the handle.
- Adjust the infeed guides to support the edge banding tape without restricting its movement.
- Release the nylon feed roller to allow smooth tape feed.
- Adjust the seat assembly to lightly support the edge banding tape.
Flush Trimmers and Panel Feeder
- Measure the thickness of the edge banding tape and set the dial indicators on the flush trimmers accordingly.
- Measure the thickness of the board and adjust the panel feeder height using the dial indicator and crank handle.
- Ensure the board is centered on the edge banding tape.
Note: Always refer to the owner's manual for specific instructions and safety precautions.
By following these steps, you can achieve a proper setup for your G0774 edge bander.