G0948 Bandsaw Setup Instructions
Unboxing and Inventory
- Unbox the G0948 bandsaw.
- Conduct a thorough inventory of all included components.
Machine Placement
- Choose a location with sufficient space for infeed and outfeed operations.
- Ensure access to a 110-volt, 15-amp power outlet.
Assembly
- Attach Rubber Feet: Install rubber feet on the bottom of each leg.
- Assemble Stand: Connect the stand legs using the short braces, then connect the leg assemblies using the long braces.
- Place Machine on Stand: Carefully place the machine on top of the assembled stand.
- Secure Machine: Bolt the machine to the stand using the provided hardware.
- Attach Table: Connect the table to the trunnion using the four removed hex bolts.
- Square Table: Loosen the table adjustment knobs, square the table to the blade using a square, and then tighten the knobs.
- Install Fence: Attach the fence to the rail using the wing bolts.
- Connect Dust Collection: Attach the appropriate dust collection hose to the machine's dust port.
Blade Setup
- Loosen Blade Guides: Raise the blade guides to the top position.
- Tension Blade: Use the tension knob to apply appropriate tension to the blade.
- Adjust Blade Tracking: Loosen the blade tracking adjustment knob and adjust the blade's position on the wheel until it's centered. Tighten the knob.
- Lower Blade Guides: Lower the blade guides to the proper position.
Test Run
- Clear Work Area: Ensure the work area is clear of obstructions.
- Power On: Turn on the machine and let it reach operating speed.
- Safety Test: Turn off the machine, remove the safety key, and attempt to restart. The machine should not start.
Additional Considerations
- Refer to the user manual for detailed instructions on blade tensioning, fence calibration, and miter gauge adjustments.
- Regularly inspect the machine for wear and tear.
- Follow recommended safety practices when operating the bandsaw.
By following these steps, you can successfully set up and operate your G0948 bandsaw.
The video below provides a comprehensive guide to the inventory, setup, and test run of the G0948 10-inch bandsaw.
We trust you will find this video to be beneficial. Please feel free to reach out to us HERE if you have any questions on how to set up the bandsaw.