Converting Your G1037Z Planer to Molding Mode
Safety First
- Always disconnect the machine from power before making adjustments.
- Wear appropriate safety gear, including safety glasses and hearing protection.
Preparation
- Gather tools: Assemble the necessary tools, including wrenches, a straight edge, and the provided hardware.
- Read manual: Review the user manual for detailed instructions and safety precautions.
Machine Conversion
- Change feed rate gearing: Replace the installed gears with the 57-tooth and 22-tooth gears to reduce the feed rate to 12 feet per minute.
- Remove dust collection: Disconnect and remove the dust collection assembly and chip deflector.
- Install molding fences and bed board: Attach the fence guide rod, molding fences, and bed board using the included hardware. Adjust the fence guide rod brackets for proper fence alignment.
Knife Installation
- Access cutter head: Loosen the gib set screws and remove the gibs and planer knives.
- Install molding knives: Insert the molding knives into the cutter head, using the L gauge for alignment. Tighten the gib set screws evenly.
- Adjust roller height: Loosen the locknuts on the infeed and outfeed roller posts. Raise the rollers to lightly contact the workpiece. Tighten the locknuts after adjustments.
Final Adjustments
- Test and adjust: Run test cuts to fine-tune knife alignment and roller pressure. Adjust as needed.
- Reassemble: Reinstall the dust collection assembly and chip deflector.
Additional Tips
- Support the workpiece on the outfeed side to prevent binding.
- Make gradual adjustments to the roller height to avoid overstressing the rollers.
- Refer to the user manual for specific details and troubleshooting.
Note: Always consult the user manual for your specific G1037Z model for complete instructions and safety precautions.
You can also follow along with the steps above in this video.
We trust you will find this video to be beneficial. Please feel free to reach out to us HERE if you have any questions on how to convert your planer moulder.