This article provides a step-by-step guide to inventorying and assembling the Grizzly G0462 Wood Lathe, detailing required tools, included accessories, and assembly instructions. It emphasizes safety, the need for assistance due to the lathe's weight, and checking all parts before use. Additional resources and specifications are available on Grizzly.com.
Machine Overview
The G0462 features:
- 16" swing over bed
- 46" distance between centers
- 2 HP motor
- Variable speed control with digital readout
For complete specifications, refer to the Specifications PDF on Grizzly.com.
Tools & Materials Needed
Before starting assembly, gather:
- At least two assistants (lathe is heavy)
- Cleaner/degreaser and shop rags
- Mounting hardware (if you plan to floor‑mount)
- Measuring tape
- Screw gun with Phillips‑head bit
- 13 mm socket wrench or open‑ended wrench
- Utility knife or box cutter
Uncrating the Machine
- Carefully remove the top and sides of the crate.
- Remove all packaging materials.
- Remove the bolts and brackets securing each stand leg for shipment.
- Set both stand legs aside on a flat surface.
- Remove the accessory box and inventory the contents.
Inventory the Included Accessories
Inside the box, you will find:
- Tool rest
- Tool rest base
- Knockout tool
- (2) 32 mm flat wrenches
- Hardware bag
The hardware bag contains:
- Live center
- Spur center
- Tool rest lock lever
- 3 mm, 4 mm, and 6 mm hex wrenches
- (8) cap screws
- (8) lock washers
Verify everything is present before beginning assembly.
Step‑by‑Step Assembly
1. Position the Stand Legs
- Place both legs in line with each other.
- Leave approximately 46.5 inches between the bases.
2. Mount the Lathe to the Stand
You must have at least two assistants for this step.
- Ensure the headstock is locked down before lifting.
- With assistance, lift the lathe onto the stand legs.
- Secure it using the included cap screws and lock washers.
3. Adjust Bed End Plates (If Needed)
If alignment prevents installation:
- Remove the lathe bed end plates.
- Remove the quill assembly.
- Slide the headstock to the opposite end of the bed.
- Reinstall the bed end plate.
- Reinstall the quill assembly.
- Attach the remaining bed end plate.
4. Install the Tool Rest Assembly
- Insert the tool rest into the tool rest base.
- Tighten the adjustable handle to secure it.
- Remove the nuts securing the clamp plate from the base.
- Place the pivot block into the bed channel.
- Reattach the clamp plate and nut.
- Tighten the lock lever until fully secure.
5. Install the Digital Readout
- Position the digital readout on top of the headstock.
- Secure using the pre‑installed Phillips‑head screws, lock washers, and flat washers.
Final Checks Before Operation
Before performing a test run or operating the lathe:
- Ensure the machine is properly positioned in your workspace.
- Review the Site Considerations section in your owner’s manual for clearance and safety guidelines.
Additional Resources
Explore Grizzly.com for a full selection of lathe accessories, turning tools, and compatible add‑ons.