This article explains how to adjust the front and rear drums on the G1066R and G1079 drum sanders, detailing preparation, drum alignment (perpendicular and parallel), and final testing steps. It emphasizes safety, tool requirements, and advises consulting the user manual for complete instructions and precautions.
In this how-to video, we'll demonstrate the process of adjusting the front and rear drums on the G1066R and G1079 drum sanders. We've also included the steps below the video so you can follow along.
Adjusting Sanding Drums on the G1066R and G1079 Drum Sander
Preparation
- Safety first: Disconnect the sander from power.
- Gather tools: Prepare a 14mm socket wrench, 4mm hex wrench, small hammer, and wooden dowel.
Drum Alignment
- Access drums: Remove the top cover of the sander.
- Check perpendicular alignment: Measure the distance between the drum edge and the nearest brace on both sides. Adjust if necessary by loosening the lock nuts, tapping the bearing block, and retightening the lock nuts.
- Check parallel alignment: Use two identical wooden boards to check drum height. Adjust the drum height using the set screws in the bearing block corners if necessary.
Final Steps
- Test run: Make test passes with scrap wood to ensure proper drum alignment and sandpaper contact.
Note: Always refer to the user manual for detailed instructions and safety precautions.