This video demonstrates the step-by-step process for replacing sandpaper on the G0449 and G0450 Drum Sanders.
We've also included step-by-step instructions below so you can follow along.
Replacing Sandpaper on G0449 and G0450 Drum Sanders
Preparation
- Gather tools: Collect a Phillips head screwdriver, tensioning tool, sandpaper, straightedge, knife, hammer, and flathead screwdriver.
- Power off: Disconnect the sander from the power source.
Removing Old Sandpaper
- Access drum: Lift the top cover and insert the tensioning tool to de-tension the sandpaper.
- Release tension: Use a screwdriver to insert into the drum and rotate it to fully release tension.
- Remove clips: Remove the sandpaper retaining clips using a flathead screwdriver.
- Unwind sandpaper: Carefully unwind the old sandpaper.
Preparing New Sandpaper
- Measure drum: Use the old sandpaper as a template or measure the drum circumference to determine the sandpaper length.
- Cut sandpaper: Cut the new sandpaper to the required size using a straightedge and knife.
Installing New Sandpaper
- Insert sandpaper: Fold the sandpaper and insert one end into a clip, then seat the clip into the tension wheel.
- Wrap sandpaper: Tightly wrap the sandpaper around the drum, ensuring no bubbles or overlaps.
- Secure second end: Fold the remaining sandpaper end into the other clip and install the clip.
- Apply tension: Remove the tensioning tool to allow the tension wheels to apply pressure.
Final Steps
- Repeat for other drum: If necessary, repeat the process for the second drum.
- Reassemble: Close the top cover and reconnect the sander to power.
Note: Always prioritize safety and follow the specific instructions provided in your owner's manual.
We trust you will find this video to be beneficial. Please feel free to reach out to us HERE if you have any questions on how to install sandpaper on your drum sander.