Please follow these instructions to program your remote.

Basic Operating Instructions:

• The green button turns the motor ON.
• The red button turns the motor OFF.
• The light on the remote should flash red when any button is pressed.
• This remote requires a 12V, type A27 battery.
• Low batteries will prevent the remote from working.
• This remote operates on a radio frequency and has a 60-foot range. It does not need to be aimed at the control box to operate. 

Programming the Remote: 

1. Confirm the machine is plugged in and switched off before programming the remote control.
2. Press and hold the black set button located on the circuit board/remote receiver (see area on photo below with red square). You will hear 2 beeps, continue to hold the set button.
   1. Note: The junction box cover must be removed to access the set button located on the circuit board/remote receiver. Use an insulated screwdriver or another non-conductive tool to press the set button.
3. While holding the black set button on the circuit board/remote receiver, press and release any button on the remote control. You will hear 3 beeps. The pairing is complete.
4. Release the black set button and test the remote.