Electrical & Power
Is this jointer dual voltage?
Yes. It can run on 110V or 220V, but it ships prewired for 110V.
Does it automatically switch between 110V and 220V?
No. To use 220V, you must rewire the motor and install the correct plug (see Owner’s Manual).
What is needed for 220V conversion?
- Disconnect from power
- Reconfigure motor wiring per manual
- Install a 6-15 plug for 220V
Important: Only a qualified electrician should perform this conversion.
What are the circuit requirements?
- 110V: 20A circuit
- 220V: 15A circuit
Does it include a power cord and plug?
Yes. It comes with a 6 ft. cord and a 5-15 plug for 110V.
Motor & Performance
What size motor does it have?
- 1 HP, TEFC capacitor-start induction motor
- Speed: 3450 RPM
- Amps: 14A at 110V, 7A at 220V
Cutting Capacity
What is the maximum cutting width and depth?
- Width: 6 in.
- Depth: 1/8 in.
What is the maximum rabbeting depth?
1/2 in.
What is the minimum workpiece size?
- Length: 8 in.
- Width: 3/4 in.
- Thickness: 1/2 in.
Fence & Table
What are the fence dimensions and stops?
- Length: 29-1/8 in.
- Height: 4 in.
- Stops: 45°, 90°, 135°
What is the table size and height?
- Length: 47-3/8 in.
- Width: 6-5/8 in.
- Floor-to-table height: 33-5/8 in.
Cutterhead & Knives
What type of cutterhead does it have?
Straight knife cutterhead with 3 knives.
Knife size and adjustment?
- Length: 6 in.
- Width: 1 in.
- Thickness: 1/8 in.
- Adjustment: Jack screws
Is there a spiral cutterhead upgrade?
Yes. The H7653 Indexable Spiral Cutterhead fits this jointer.
Can you install the spiral cutterhead before shipping?
No, but we offer models with factory-installed spiral heads.
Dust Collection
Does it have a dust port?
Yes. One 4" dust port.
Construction & Mobility
What is it made of?
- Table and fence: Cast iron
- Base: Steel
- Guard: Die-cast metal
Does it have a mobile base?
Yes. A built-in mobile base is included.