Important Disclaimer: This article references a model that is no longer in production. Please note that the availability of replacement parts or discussed accessories is not guaranteed.
General Questions
Where is the serial number located?
The serial number is on the ID label on the front of the cabinet.
How long does assembly take?
Assembly and setup typically take about 1–1.5 hours.
Where is the G7209 manufactured?
This table saw is made in Taiwan.
Cutting & Blade
What is the maximum stack dado head width?
The saw arbor allows a maximum stack of 13/16".
What is the maximum width of cut to the right of the blade?
50-3/4" with the included fence and rails; optional long rails allow up to 50".
What is the maximum depth of cut?
At 90°: 5"
At 45°: 3-9/16"
Which way does the blade tilt?
The blade tilts to the right as you face the saw from the operator’s position.
Motor & Power
What motor does the G7209 use?
5 HP, single-phase, 2860 RPM TEFC capacitor-start induction motor, prewired for 220V.
How is power transferred to the blade?
Via a quadruple V-belt drive for smooth and reliable operation.
How many V-belts are on this machine?
Four matched V-belts.
What type of switch does it have?
Magnetic switch with thermal overload protection.
Table & Fence
What are the table dimensions?
Standard with extension wings: 48-1/2" W × 38" D
Main table thickness: 2"
Floor-to-table height: 35-1/2"
What is the fence like?
Camlock T-Shape fence with HDPE face (Shop Fox Classic style). Length: 47-1/4", Width: 3-3/8", Height: 2-1/2". Front rail locks only.
What are the fence rails like?
Square steel tubing/angle iron, 77-3/8" L × 2" W × 2" H.
Does the saw have a miter gauge?
Yes, T-slot type, 1" wide × 1/2" high.
Dust Collection
Does this machine have a dust port?
Yes, a 4" dust port is located on the lower right-hand side.
What are the CFM requirements for a dust collector?
A dust collector should handle approximately 500 CFM for a 14" table saw. This is an average figure and depends on hose length and overall system efficiency.
Where do I install a dust hood?
Attach a dust hood to the 4" dust port on the lower right-hand side. Adaptors may be required depending on your dust collection setup.
Construction & Materials
What is the table made of?
Precision-ground cast iron with cast iron wings.
What is the cabinet made of?
Pre-formed steel.
What are the trunnions made of?
Cast iron.
What is the fence made of?
Extruded aluminum with HDPE face.
What are the rails made of?
Steel square tubing and angle iron.
What is the guard made of?
Clear plastic.
What are the arbor bearings like?
Sealed and permanently lubricated.
Key Specifications
Blade Diameter: 14" max
Arbor Size: 5/8", 1"
Arbor Speed: 3850 RPM
Motor: 5 HP, single-phase, 2860 RPM
Power Transfer: Quadruple V-belt drive
Max Rip Right/Left: 50-3/4" / 9-3/16"
Max Depth of Cut: 5" (90°), 3-9/16" (45°)
Table: 48-1/2" × 38" with extension wings, 2" thick
Fence: Camlock T-Shape, front locking, 47-1/4" × 3-3/8" × 2-1/2"
Dust Port: 4"