Important Disclaimer: This article references a model that is no longer in production. Please note that the availability of replacement parts or discussed accessories is not guaranteed.
What power does this table saw require?
The saw can be wired for 220V or 440V, 3-phase, 60 Hz power. It comes prewired for 220V. The full-load current rating is 26A, requiring a minimum 30A circuit.
How much horsepower does the motor have?
This saw is equipped with a 7.5 HP, 3-phase TEFC induction motor running at 2860 RPM. Power is transferred through four matched V-belts.
Does this machine have a dust port?
Yes. The saw has a 4″ dust port located on the lower right-hand side of the cabinet.
What are the CFM requirements for dust collection?
A dust collector should be rated to handle at least 500 CFM for table saw operation. Actual performance depends on hose length, duct layout, and the efficiency of your dust collection system.
Is the fence front and rear locking?
No. The fence locks on the front rail only to ensure consistent results. Despite this, the fence is rigid and stable when locked in position.
What is the maximum stack dado width?
The arbor accepts a dado stack up to 13/16″ wide.
What is the maximum rip capacity to the right of the blade?
This saw will rip up to 50-3/4″ to the right of the blade with the included fence and rails.
What is the maximum rip capacity to the left of the blade?
The maximum rip capacity to the left of the blade is 9-3/16″.
What is the maximum depth of cut?
At 90°: Up to 5″
At 45°: Up to 3-9/16″
Which way does the blade tilt?
The blade tilts to the right when viewed from the operator’s position.
What type of fence does this saw use?
It comes with a Camlock T-shape fence with HDPE face (Shop Fox Classic). The fence length is 47-1/4″, and the rails are made of steel tubing/angle iron.
What are the table dimensions?
With the extension wings installed, the table measures 48-1/2″ wide × 38″ deep. The floor-to-table height is 35-1/2″.
What is the warranty on this saw?
This table saw is covered by a 1-year warranty.
Where is the serial number located?
The serial number is found on the ID label on the front of the cabinet.
Where is this machine manufactured?
This saw is manufactured in Taiwan. It is not ISO 9001 certified and does not have NRTL certification.
Key Specifications
Motor: 7.5 HP, 3-phase, TEFC induction (2860 RPM)
Power Requirement: 220V or 440V, 3-phase, 60 Hz
Full-Load Current Rating: 26A
Minimum Circuit Size: 30A
Switch Type: Magnetic switch with thermal overload protection
Voltage Conversion Kit: P7210154
Recommended Phase Converter: G5845
Power Transfer: Quadruple V-belt drive
Table Saw Type: Cabinet
Maximum Blade Diameter: 14″
Arbor Size: 5/8″ & 1″
Arbor Speed: 3850 RPM
Maximum Dado Width: 13/16″
Blade Tilt: Right, up to 45°
Maximum Depth of Cut: 5″ at 90°, 3-9/16″ at 45°
Maximum Rip Capacity: 50-3/4″ right, 9-3/16″ left
Table Size (with extension wings): 48-1/2″ W × 38″ D
Fence Type: Camlock T-shape with HDPE face (Shop Fox Classic)
Dust Port: 4″ (lower right-hand side)
Compatible Mobile Base: D2058A
Overall Table Height: 35-1/2″
Warranty: 1 year
Country of Origin: Taiwan