Important Disclaimer: This article references a model that is no longer in production. Please note that the availability of replacement parts or discussed accessories is not guaranteed.
1. Does this machine have a dust port?
Yes. There is a 4-inch dust port located on the lower right-hand side for efficient dust collection.
2. Is the fence front and rear locking?
No. The fence locks on the front rail only to ensure consistent alignment. It is very rigid when locked in position.
3. What is the maximum stack dado head width I can use with this saw?
The arbor will accommodate a 13/16" stack dado set.
4. What is the maximum rip capacity to the right of the blade?
This saw will rip up to 50 inches to the right of the blade and 10 inches to the left.
5. What is the maximum depth of cut at 90°?
The saw will cut up to 4 inches at 90° and 2-5/8 inches at 45°.
6. How many V-belts does this saw use?
It uses three matched V-belts for smooth power transfer.
7. What are the CFM requirements for a dust collector?
A dust collector should handle 500 CFM for a 12" table saw. This is an average figure and may vary based on hose length and system efficiency.
8. Which way does the blade tilt?
The blade tilts to the right as viewed from the operator’s position.
9. What are the electrical requirements?
- Power: 220V, single-phase, 60 Hz
- Full-Load Current: 27A
- Minimum Circuit Size: 30A
- Plug: Not included (recommended type: NEMA L6-30)
10. What type of motor does this saw have?
A 5 HP TEFC capacitor-start induction motor running at 3450 RPM, delivering heavy-duty cutting power.
Key Specifications
- Blade Size: 12"
- Arbor Size: 5/8" and 1"
- Arbor Speed: 4140 RPM
- Max Dado Width: 13/16"
- Max Rip Capacity: 50" right, 10" left
- Table Size: 48" W × 30-1/8" D (with wings)
- Fence Type: Shop Fox Classic Camlock T-Style
- Dust Port: 4"
- Motor: 5 HP, 220V, 27A