Important Disclaimer: This article references a model that is no longer in production. Please note that the availability of replacement parts or discussed accessories is not guaranteed.
1. What are the differences between all of the G1023S/Z series table saws?
- G1023S: Basic cabinet table saw with the upgraded Shop Fox Classic Fence.
- G1023Z: Includes a rail-mounted switch, hinged motor cover, and Shop Fox fence.
- G1023ZX: Same as G1023Z but with a 5 HP motor for heavier-duty cutting.
2. What is the maximum stack dado width I can use with this saw?
The arbor will accommodate a 13/16" stack dado set.
3. Does this machine have a dust port?
No. However, our G1838 Dust Collection Adapter can be easily adapted to fit this saw.
4. Can I install an aftermarket fence on this saw?
Yes. The table is a standard 27" deep, so most aftermarket fences will fit. Some may require rail modifications.
5. What is the maximum rip capacity?
- Right of blade: 25" with included rails (48" with optional long rails, part G4725).
- Left of blade: 8".
6. How many V-belts does this saw use?
The saw uses three matched V-belts for smooth power transfer.
7. Are other motors available for this saw?
Yes. Grizzly offers 3 HP and 5 HP motors for this model.
8. What are the CFM requirements for a dust collector?
A dust collector should handle 450 CFM for a 10" table saw. This is an average figure and may vary based on hose length and system efficiency.
9. Which way does the blade tilt?
The blade tilts to the right as viewed from the operator’s position.
10. What are the electrical requirements?
- Power Requirement: 220V, single-phase, 60 Hz
- Full-Load Current: 28A
- Minimum Circuit Size: 30A
- Power Cord: 10 ft, 10 AWG (plug not included)
11. What is the maximum cutting depth?
- At 90°: 3-1/8"
- At 45°: 2-1/8"
12. What type of fence comes with this saw?
The saw includes a Shop Fox Original Fence with front/rear locking and steel face.
Key Specifications
- Blade Size: 10"
- Arbor Size: 5/8"
- Arbor Speed: 4200 RPM
- Max Dado Width: 13/16"
- Table Size: 40-1/8" W × 27" D (with wings)
- Fence Rail Length: 47"
- Dust Port: 4"
- Motor: 5 HP, TEFC capacitor-start induction