Important Disclaimer
This article references a model that is no longer in production. Please note that the availability of replacement parts or discussed accessories is not guaranteed.
What are the specifications of the Grizzly G1022ZFX Table Saw?
Design type: Floor model
Table size: 27-1/8" D x 20-1/8" W (standard), 27-1/8" D x 40-5/8" W with extension wings
Table height: 37"
Blade diameter: 10"
Maximum depth of cut: 3-1/8" at 90°, 2-1/8" at 45°
Maximum rip: 25" right of blade (standard), 48" with optional extension rails, 11" left of blade
Arbor size: 5/8" x 1-1/4"
Maximum dado width: 13/16"
Motor: 2 HP, single-phase, 110V/220V, TEFC capacitor-start induction, 3450 RPM, Power Twist® link belt drive
Fence: Shop Fox® heavy-duty PROZ model
Dust collection: 4" ported dust hood included
Table construction: Precision-ground cast iron with cast iron wings
Stand construction: Pre-formed steel
Miter gauge: Cast iron/steel, adjustable for side play
Trunnions: Cast iron
Bearings: Shielded and lubricated ball bearings
Weight: 325 lbs. net, 340 lbs. shipping
Assembly time: Approximately 45–60 minutes
What is the difference between the G1022ZFX and other G1022 series table saws?
G1022ZFX: Features cast iron wings, a 2 HP U.S. motor, Power Twist® link belt, Shop Fox® PROZ fence, and a 4" dust port.
G1022ZF: Similar to the ZFX but may vary slightly in motor or fence features.
G1022Z: Cast iron wings, 1-1/2 HP American motor, 4" dust port, redesigned fence.
G1022SM: Stamped metal wings and fewer features compared to the Z series.
What is the maximum stack dado blade width I can use?
The saw arbor can accommodate a dado stack up to 13/16" wide.
Which way does the blade tilt?
The blade tilts to the right when facing the saw from the operator’s position.
What are the dust collection requirements?
A dust collector capable of at least 450 CFM is recommended for a 10" table saw. Actual performance may vary depending on hose length, fittings, and the overall efficiency of the dust collection system.
What is the maximum rip capacity with standard and extension rails?
Standard rails: up to 25" to the right of the blade
Optional extension rails: up to 48" to the right of the blade
Left of blade: up to 11"
What are the motor specifications?
Horsepower: 2 HP
Phase: Single-phase, 60 Hz
Voltage: 110V/220V
RPM: 3450
Drive: Power Twist® link belt drive
Switch type: Push-button ON/OFF
Can I install aftermarket fences or accessories on this saw?
Yes. The table is standard depth (27") and width (20-1/8"), so many aftermarket fences and accessories may fit, but some may require minor adjustments or modifications.
What is the construction of the G1022ZFX table and stand?
The table is precision-ground cast iron with cast iron wings, the stand is pre-formed steel, and trunnions are cast iron. Bearings are shielded and lubricated for long-lasting performance.