Important Disclaimer: This article references a model that is no longer in production. Please note that the availability of replacement parts or discussed accessories is not guaranteed.
General Questions
What is the difference between the G1022Z and other G1022 series table saws?
The G1022Z features cast iron wings and a redesigned fence with T-slots. The G1022SM has stamped metal wings and fewer features, while other Z series saws may include upgraded aftermarket fences and larger motors.
How long does assembly take?
Assembly typically takes about 1–1.5 hours.
Where is the serial number located?
The serial number is located on the ID label on the saw.
Cutting & Blade
What is the maximum stack dado head width?
The saw arbor allows a maximum stack of 13/16".
What is the maximum width of cut to the right of the blade?
With standard rails: 24"
With optional extension rails: 48"
Which way does the blade tilt?
The blade tilts to the right as you face the saw from the operator’s position.
What is the maximum depth of cut?
At 90°: 3-1/8"
At 45°: 2-1/8"
What is the maximum rip to the left of the blade?
11"
Motor & Power
What motor does the G1022Z use?
11-1/2 HP TEFC capacitor-start induction motor, single-phase, 3450 RPM, prewired for 110V (can also run 220V).
Is a larger motor available?
Yes, this saw accepts all 3450 RPM motors with a NEMA 56 frame and a 5/8" shaft.
How is power transferred to the blade?
Via a belt drive system.
What type of switch does it have?
Push-button ON/OFF switch.
Table & Fence
What are the table dimensions?
Standard: 27-1/8" D × 20-1/8" W
With extension wings: 27-1/8" D × 40-5/8" W
With wings and fence rails: 48" W × 44" D
What is the fence like?
Heavy extruded aluminum with T-slots, front and rear locking, and a micro-adjust knob.
Can I install an upgraded aftermarket fence?
Yes. The table is a standard 27" deep. Some aftermarket fences may require modifications to mount the rails.
Dust Collection
How do I install a dust hood?
Use the G2480 Dust Hood with a plywood or sheet metal adapter mounted between the saw body and stand. Center the dust hood on the adapter and cut a square hole matching the inside flange of the dust hood. Secure with sheet metal screws.
What are the CFM requirements for a dust collector?
A dust collector should handle approximately 450 CFM for a 10" table saw. Requirements vary depending on hose length and overall efficiency of your dust collection system.
Construction & Materials
What is the table made of?
Precision-ground cast iron with open-ribbed wings.
What is the stand made of?
Pre-formed steel.
What are the bearings like?
Shielded and lubricated ball bearings.
What are the rails and guard made of?
Rails: Chrome-plated tubing (44" × 13/8")
Guard: Steel and clear plastic
Key Specifications
Cutting Capacity: 10" blade, 3-1/8" max depth at 90°, 2-1/8" at 45°
Maximum Rip Right/Left: 24" / 11" (48" optional with extension rails)
Maximum Stack Dado: 13/16"
Motor: 11-1/2 HP, 3450 RPM, TEFC, single-phase
Table Size: 27-1/8" × 20-1/8" (standard), 27-1/8" × 40-5/8" (with wings)
Fence: Heavy extruded aluminum, front & rear locking, micro-adjust knob
Arbor: 5/8" × 11-1/4", 4,700 RPM
Dust Port: Compatible with G2480 Dust Hood