General Questions
How tall of a cutterhead can I put on this machine?
The spindle will accept a 5" tall cutterhead.
Is a router bit spindle available for this machine?
No. A router bit spindle is not available for this model.
Does this machine have a dust hood?
Yes. The G5913 has a 4" dust port located on the back of the fence shroud.
Spindle & Cutterhead Questions
What is the maximum cutter diameter I can use on this machine?
The maximum cutter diameter is 5-7/8".
How is the spindle held in place?
The spindle is secured with a threaded drawbar that runs through the drive spindle.
How do I know how fast to run my cutters?
Operating speed depends on the cutter diameter and wood hardness:
Smaller diameter cutters / softer wood → faster speeds
Larger diameter cutters / harder wood → slower speeds
What spindle sizes are available?
3/4", 1", and 1-1/4".
What is the spindle travel?
The spindle travel is 3-1/4".
What is the exposed spindle length?
Approximately 7-3/8".
What spindle speeds are available?
3600, 5100, 8000, and 10,000 RPM.
Does the spindle tilt?
Yes, the spindle tilts from 0° to 45°.
Electrical Questions
What voltage is required to run this machine?
The G5913 operates on 220V, single-phase, 60 Hz.
What size circuit breaker do I need?
A 30-amp circuit is required.
Is a plug included?
No. The recommended plug type is L6-30, and a 3-wire, 10 AWG “S”-type cord rated 300 VAC should be used.
Does it have overload protection?
Yes. The control panel includes a magnetic switch with overload protection.
Table & Fence Questions
What size is the table?
The cast-iron table measures 35-1/2" L x 28" W x 2-3/8" thick.
What is the floor-to-table height?
34-3/4".
What type of fence does it use?
The fence is cast iron with wood faces, measuring 29" long, 4-1/4" tall, 9/16" wide.
Does it include a miter gauge?
Yes. A cast-iron miter gauge is included, adjustable 0–60° left/right, running in a T-slot.
How many table inserts are included?
One table insert: ID 2-1/8"; OD 3", 3-1/2", 7".
What is the table counterbore size?
Diameter: 7"; depth: 5/8".
Dust Collection Questions
How many dust ports does this machine have?
One 4" dust port located on the back of the fence shroud.