General Questions

How tall of a cutterhead can I put on this machine?
The spindle will accept a 5" tall cutterhead.

Is a router bit spindle available for this machine?
No. A router bit spindle is not available for this model.

Does this machine have a dust hood?
Yes. The G5015 is equipped with a 4" dust port located on the back of the fence shroud.

Spindle & Cutterhead Questions

What is the maximum cutter diameter I can use?
The maximum cutter diameter is 4-1/2" to 7/8".

How is the spindle held in place?
The spindle is secured with a threaded drawbar that runs through the drive spindle.

How do I know how fast to run my cutters?
Operating speed depends on the diameter of the cutter and the hardness of the wood:

• Smaller diameter cutters / softer wood → faster speeds

• Larger diameter cutters / harder wood → slower speeds

What spindle sizes are included?
3/4", 1", and 1-1/4".

What is the spindle travel?
The spindle travel is 3-1/4".

How much spindle length is exposed?
Exposed spindle length ranges from 5-7/8" to 6-7/8".

What spindle speeds are available?
3600, 5100, 8000, and 10,000 RPM.

Electrical Questions

Can I run this machine on 110V?
No. The G5015 requires 220V, single-phase power.

What size circuit breaker do I need?
A 30-amp breaker is recommended.

Is a plug included?
No. A plug is not included. The recommended plug type is L6-30, and a 3-wire, 10 AWG “S”-type cord rated 300 VAC should be used.

Does it have overload protection?
Yes. The control panel includes a magnetic switch with overload protection.

Table & Fence Questions

What size is the table?
The cast-iron table measures 35-1/2" L x 28" W x 2-5/16" thick.

What is the floor-to-table height?
34-3/4".

What type of fence does it use?
The fence is cast iron with wood faces, measuring 33-3/8" long, 4-1/4" tall, 9/16" wide.

Does it include a miter gauge?
Yes. A cast-iron miter gauge is included, with a 0–60° left/right adjustment, running in a T-slot.

How many table inserts are included?
Three table inserts: ID 2", 3", 3-1/2"; OD 3", 3-1/2", 7".

What is the table counterbore size?
Diameter: 7", depth: 5/8".

Dust Collection Questions

How many dust ports does this machine have?
One dust port, 4" in diameter, located on the back of the fence shroud.

Accessories & Mobility

What mobile base works with this machine?
The D2058A Mobile Base is recommended.