General Questions
How tall of a cutterhead can I put on this machine?
The spindle will accept a 5" tall cutterhead.
Is a router bit spindle available for this machine?
No. A router bit spindle is not available for this model.
Does this machine have a dust hood?
Yes. The G7214Z has a 4" dust port located on the back of the fence shroud.
Spindle & Cutterhead Questions
What is the maximum cutter diameter I can use on this machine?
The maximum cutter diameter is 5-7/8".
How is the spindle held in place?
The spindle is secured with a threaded drawbar that runs through the drive spindle.
How do I know how fast to run my cutters?
Operating speed depends on the cutter diameter and wood hardness:
Smaller diameter cutters / softer wood → faster speeds
Larger diameter cutters / harder wood → slower speeds
What spindle sizes are available?
3/4", 1", and 1-1/4".
What is the spindle travel?
The spindle travel is 3-1/4".
What is the exposed spindle length?
Approximately 5-7/8" – 6-7/8".
What spindle speeds are available?
3600, 5100, 8000, and 10,000 RPM.
Does the spindle tilt?
No tilt adjustment is specified; this is a standard shaper spindle.
What spindle openings are available?
2", 3", 3-1/2", and 7".
Electrical Questions
What voltage is required to run this machine?
The G7214Z operates on 220V or 440V, 3-Phase, 60 Hz.
What size circuit breaker do I need?
220V: 30A minimum
440V: 15A minimum
Is a plug included?
No. Recommended plug type for 220V is L15-30, and the recommended cord is 4-wire, 10 AWG, 300 VAC “S”-type.
Does it have overload protection?
Yes. The control panel includes a magnetic switch with overload protection.
Can I convert between 220V and 440V?
Yes. The machine uses voltage conversion kit P7214Z156 for 440V, and a recommended phase converter is G7978.
Table & Fence Questions
What size is the table?
The cast-iron table measures 35-1/2" L x 28" W x 2-5/16" thick.
What is the floor-to-table height?
34-3/4".
What type of fence does it use?
The fence is cast iron with wood faces, measuring 33-3/8" long, 4-1/4" tall, 9/16" wide.
Does it include a miter gauge?
Yes. A cast-iron miter gauge is included, adjustable 0–60° left/right, running in a T-slot.
How many table inserts are included?
Three inserts: ID 2", 3", 3-1/2"; OD 3", 3-1/2", 7".
What is the table counterbore size?
Diameter: 7"; depth: 5/8".
Dust Collection Questions
How many dust ports does this machine have?
One 4" dust port, located on the back of the fence shroud.