Electrical & Motor
What are the power requirements?
240V, single-phase, 60 Hz, 12A full load, 15A minimum circuit.
Does it include a power cord and plug?
Yes. It comes with a 6 ft. cord (14 AWG) and a 6-15 plug.
How long is the cord?
6 feet.
What size power cable does it use?
14 AWG.
What type of motor does it have?
3 HP TEFC capacitor-start induction motor, 3450 RPM.
Is the motor safe for 50 Hz?
No. It is designed for 60 Hz only.
Will this motor operate at 208V single phase?
Yes.
Does this machine have reverse?
Yes. It features forward and reverse capability.
What if I need to replace the V-belt quickly?
The 7 x 690L V-belt can be purchased at most bearing and belt supply stores.
Cutters & Spindles
What spindle sizes are included?
1/2", 3/4", and 1".
Can 1/2" shank bits be used?
Yes. The 1/2" spindle accepts 1/2" bore cutters.
Does it include a collet attachment for router bits?
No. A router bit collet is sold separately (G1794).
Is a router bit spindle available?
Yes. The G1794 router bit spindle holds 1/4" and 1/2" shank router bits.
What’s the maximum cutter diameter?
5-1/2". For safety and quality, take multiple passes.
What’s the maximum cutter height?
2-1/2".
Is a taller spindle available for taller cutters?
Yes. The G2910 4" spindle accepts cutters up to 3" tall.
Is a 1-1/4" spindle available?
No. For cutters with a 1-1/4" bore, use two T-bushings to reduce to 1".
How is the spindle held in place?
With a threaded draw bar running through the drive spindle.
What is the spindle travel?
3 inches.
What are the spindle speeds?
7,000 and 10,000 RPM.
Table & Fence
What is the table size?
28-1/4" x 21-3/4" (30-1/2" wide with extension wings).
What is the fence size?
26-15/16" long x 2-3/4" high.
Does it include a miter gauge?
Yes. It includes a cast-iron miter gauge with 0–60° L/R adjustment.
Dust Collection
Does the machine have a dust port?
Yes. It has one 3" dust port.
Will the optional G4839 dust hood fit an older G1026?
Yes, but four holes must be drilled and tapped for the bolts.
Power Feeder Compatibility
Is this machine big enough for the 1 HP power feeder?
Yes, but we recommend through-bolting the feeder to the table and bolting the shaper to the floor for stability.
Other Details
Where is this product made?
Taiwan, in an ISO 9001 certified factory.