General Questions

What is the warranty on the G1015?
The G1015 comes with a 1-year warranty from the date of purchase.

Where is the serial number located?
The serial number is located on the ID label.

How long does it take to assemble?
Assembly and setup typically take about 1 hour.

Can this machine be wired for 220 volts?
No, the G1015 is designed for 110V single-phase operation only.

How tall does the machine stand?
With the belt arm in the upright position, the machine stands 39" tall.

Belt Sander

What size sanding belt does the G1015 use?
The belt is 2" wide and 72–76" long, running at 3,600 FPM.

Is the sanding belt supported by a platen?
Yes, the graphite-coated platen supports the sanding belt over a length of 9-1/4".

What type of joints do the sanding belts have?
Grizzly sanding belts for this machine use lap joints.

Does the belt assembly tilt or lock in position?
Yes, the sanding belt assembly can tilt 0–90° and locks securely anywhere between full horizontal and full vertical.

What is the diameter of the lower belt wheel?
The lower belt wheel has a diameter of 8".

Is a larger lower belt wheel available?
Yes, an optional 10" lower belt wheel is available.

How does belt tension work?
The G1015 uses a quick-release tension system for easy belt changes.

What is the maximum height of the belt in the vertical position?
The maximum height is 39".

Optional Pneumatic Sanding Drums

How much air pressure is needed in the pneumatic sanding drums?
A maximum of 10 PSI is recommended. A bicycle pump works best for inflation.

Motor & Power

What type of motor does the G1015 use?
The G1015 uses a 1 HP, 110V, single-phase, TEFC capacitor-start induction motor with a spindle speed of 1,725 RPM.

Is it direct or belt-driven?
This machine is direct drive.

Construction & Materials

What materials are used in construction?

• Base & Stand: Cast Iron

• Platen: Graphite coated

• Paint/Finish: Epoxy

Where is the machine made?
The G1015 is manufactured in Taiwan.

Replacement Parts

Is it possible to purchase the entire sanding belt assembly without the motor?
Yes. You can order Part Number P1015089A. Note that the motor requires a long shaft to fit this assembly.

Key Specifications

• Belt Size: 2" x 72–76"

• Belt Speed: 3,600 FPM

• Belt Tilt: 0–90°

• Platen: Graphite coated, 9-1/4" length x 1-7/8" width

• Lower Belt Wheel Diameter: 8" (optional 10")

• Motor: 1 HP, 110V, single-phase, direct drive

• Max Height of Belt (Vertical): 39"

• Dust Port: Not included

• Mounting Holes: 8 holes, 1/2" diameter

• Country of Origin: Taiwan

• Warranty: 1 Year