1. What type of power does the G4173 Power Feeder require?
The G4173 runs on 120V, single-phase, 60 Hz power. It comes prewired for 120V and uses a standard 5-15 plug, making it compatible with most household outlets.
2. What is the power draw of the motor?
The motor is 1/8 HP and draws 1.2 amps. A 15A circuit is recommended for safe operation.
3. Is the power cord included?
Yes. The G4173 includes a 9 ft. power cord (18 AWG) with a plug installed, so it’s ready to use right out of the box.
4. What type of motor does the power feeder use?
The G4173 uses a universal, single-phase motor with speeds ranging from 550 – 3300 RPM. It features a gear drive power transfer system with sealed, permanently lubricated bearings for long service life and minimal maintenance.
5. How many feed speeds does the G4173 have?
This feeder offers variable speed control through an ON/OFF dial, with a feed speed range of 6.5 – 39 feet per minute (FPM). This allows you to adjust the pace for different materials and applications.
6. What directions can the feeder operate in?
The rollers can rotate forward or reverse. The feeder also has a 360° swing, with 10-1/4" of vertical and horizontal movement, providing maximum flexibility for positioning.
7. What are the workpiece requirements?
The G4173 can handle workpieces with a minimum length of 5 inches. For best results, ensure stock is flat and properly supported during feeding.
8. How many rollers does the G4173 Power Feeder have?
It includes three rollers, each measuring 1-1/8" wide and 3" in diameter. The rollers are made from synthetic rubber for smooth, consistent feeding.
9. What is the maximum roller height?
The rollers can be adjusted up to 6 inches above the table surface and feature a 5/16" suspension to accommodate slight stock variations.
10. What materials is the feeder constructed from?
- Housing: Cast aluminum
- Supports: Cast iron
- Column: Steel (15/16" diameter)
- Rollers: Synthetic rubber
- Finish: Durable enamel paint
This combination ensures strength, stability, and durability for heavy shop use.
11. How long does assembly take?
Assembly and setup take approximately 30 minutes.
12. Where is the serial number located?
The serial number is located on the motor specification label.
13. Is the G4173 Power Feeder certified?
Yes. It is manufactured in an ISO 9001-certified factory in Taiwan and is NRTL-certified for compliance with safety standards.
14. What is the warranty?
The G4173 comes with a 1-year warranty covering defects in materials and workmanship.
15. What is this size of stock feeder good for?
The G4173 is perfect for small trim mouldings, typically used with small shapers or router tables.
16. Do I really need a power feeder for small, lightweight mouldings?
Yes—especially for long pieces like 8-foot mouldings. Without a power feeder:
- Hesitation during hand feeding can cause divots in the workpiece.
- A power feeder ensures consistent feed pressure, preventing divots and producing a smoother, more precise cut.
17. Where should I mount the power feeder?
Mounting location depends on the task:
- Keep the feeder out of the way, but
- Ensure there’s enough space to adjust the feeder head for your workpiece.
18. How difficult is it to mount the power feeder?
Mounting is straightforward:
- Drill bolt holes and use nuts and washers on the backside for a secure fit.
- Tapping the holes may not be strong enough depending on the table thickness.