What power requirements does the G5851Z have?
The planer requires 220V, single-phase, 60 Hz power. It comes prewired for 220V and has a full-load current rating of 39A. A minimum 50A circuit is recommended, and it must be hardwired to a shutoff switch.
Does the G5851Z come with a plug?
No, this planer requires permanent wiring. It must be hardwired into a shutoff switch for safe operation.
What type of switch does it use?
The G5851Z is equipped with a control panel featuring magnetic switch protection to prevent accidental restarts after power loss.
How powerful is the motor?
Main Motor: 5 HP, single-phase, 25A, 3500 RPM, TEFC capacitor-start induction motor with twin V-belt drive.
Feed Motor: 2 HP, single-phase, 14A, 3500 RPM, TEFC capacitor-start induction motor with belt drive and variable-speed pulley.
Both motors use shielded, permanently lubricated bearings for long service life.
What are the maximum cutting capacities?
Planer size: 24"
Max. cut width: 24"
Max. cut depth (full width): 1/16"
Max. cut depth (6" wide board): 1/8"
Stock thickness range: 1/4" to 7"
Minimum stock length: 8"
What type of cutterhead does it use?
The G5851Z features a 4-knife cutterhead with HSS, single-sided solid knives.
Cutterhead diameter: 3-1/8"
Knife size: 24" x 1" x 1/8"
Cutterhead speed: 5200 RPM
Cuts per minute: 20,800
Knives are adjustable with jack screws for precise setup.
What are the feed rates?
The planer has a variable feed rate of 17–26 feet per minute (FPM), adjustable via the variable-speed pulley drive.
What are the table specifications?
Table bed size: 31-1/8" L x 24-1/8" W x 3-1/2" thick
Table movement range: 8"
Bed rollers: 2, lever-adjustable
Floor-to-table height: 22-1/2" – 30"
Precision-ground cast iron construction for stability and accuracy
What dust collection is required?
The G5851Z includes a 5" dust port. A dust collector is recommended for safe and efficient operation.
How heavy-duty is this planer’s construction?
The planer is built with cast-iron tables and body, steel cutterhead assembly, and segmented steel infeed rollers. It also features:
Board return rollers
Segmented chip breaker
Handwheel depth adjustment
Grease fittings on the cutterhead
Dust covers to protect vertical support columns and leadscrews
This makes it a durable, industrial-grade machine.
How long does assembly take?
Assembly and setup take approximately 15 minutes.
Is a mobile base available?
Yes, the D2058A mobile base is compatible with the G5851Z for easier movement around your shop.
Where is it made?
The G5851Z is manufactured in Taiwan and comes with a 1-year warranty.
How do I find the serial number?
The serial number is located on the ID label on top of the machine. surprises when your machine arrives.
What’s the difference between the G5851Z and G7213Z?
G5851Z: Prewired for 220V, single-phase power
G7213Z: Prewired for 220V, 3-phase power, and convertible to 440V, 3-phase
Otherwise, the machines are similar in function, but the power requirements are different. Be sure your shop is wired accordingly before ordering.