Important Disclaimer: This article references a model that is no longer in production. Please note that the availability of replacement parts or discussed accessories is not guaranteed.

What is the maximum diameter of round stock that this machine will cut?

The maximum round stock capacity is 4-1/2" in diameter.

How do you change speeds on this machine?

This machine has a three-step pulley and V-belt system. To change speeds, the motor is unlocked and pivoted to release tension on the belt, which is then moved to the pulley step corresponding to the desired speed. Speed changes are quick and easy.

What kind of down feed mechanism does this machine have?

This machine relies on gravity and an adjustable counter-balancing spring to control the down feed rate.

Can I cut wood on this machine?

We don't recommend it. The blade moves too slowly for woodworking, and the blades typically sold for this size machine do not generally work well for wood.

What are the blade speeds and sizes?

The saw has three blade speeds: 80, 120, and 220 FPM. The standard blade length is 64-1/2".

What is the maximum cutting capacity for rectangular stock?

At 90°, the machine can cut rectangular stock up to 6" wide and 4-1/2" high. At 45°, the maximum width is 3" and height is 5". At 30°, the maximum width is 4-3/4" and height is 5".

What is the maximum cutting capacity for round stock?

At 90°, the machine can cut round stock up to 5" in diameter. At 45° and 30°, the maximum round stock diameter is 3" and 4-3/4", respectively.

What angle cuts can this machine make?

This bandsaw can make cuts from 45° to 90°.

What type of motor does this machine have?

The saw uses a 1/2 HP TEFC capacitor-start induction motor. It is single-phase, 60 Hz, prewired for 110V, drawing 9A at 110V and 4.5A at 220V. The motor runs at 1720 RPM and uses shielded, permanently lubricated bearings with an internal centrifugal switch.

What are the electrical requirements for this bandsaw?

The machine can run on 110V or 220V, single-phase, 60 Hz. Minimum circuit size is 15A for both voltages. The machine includes a 6 ft. power cord, 18 AWG, with plug included. It uses an automatic shut-off switch.

What is the construction of this bandsaw?

The main body, upper and lower wheels, and table are cast iron. The stand is sheet metal, and the wheel cover is pre-formed steel. The table is precision-ground cast iron and finished with epoxy paint.

What are the table dimensions and height?

The table measures 9-5/8" long and 9-1/2" wide. The floor-to-cutting-area height is 32-1/2".

What additional features does this bandsaw include?

The saw includes a vertical work table position, a stop for stock, wheels for moving the machine, and a blade.

How long does it take to assemble and set up this machine?

Assembly and setup typically take about 30 minutes.

Where is the serial number located?

The serial number is on the ID label located on the body frame of the machine.

Where is this machine manufactured?

The bandsaw is manufactured in Taiwan.

Is this machine certified by ISO or other testing labs?

Yes, it is produced in an ISO 9001 factory, demonstrating a commitment to quality management systems. However, it is not certified by a nationally recognized testing laboratory (NRTL).