What is the Grizzly G0774 Edge Bander designed for?
The G0774 is a fully automatic edge bander built for small to mid-size cabinet shops or production facilities that want to upgrade their edge banding capabilities. It is designed for fast-paced production while remaining flexible enough to handle a wide variety of materials, including ABS, PVC, laminates, wood tape, and wood strips.
What panel sizes and edgebanding thicknesses can the G0774 handle?
Panel thickness: 1/2" – 1-3/4"
Minimum panel width: 4-3/4"
Minimum panel length: 9-1/2"
Edgebanding thickness: 0.5 – 3 mm
Feed speed: 16 feet per minute
What type of glue system does the G0774 use?
The G0774 features a Teflon-coated glue pot with five heating elements and a motorized glue spindle. The heated infeed fence ensures better glue dispersion for consistent, high-quality bonding. The glue pot has a 34 oz. capacity, suitable for long production runs.
What motors are included in the G0774?
The machine uses multiple independent motors for precise operation:
Feed motor: 3/4 HP, gear-driven
Glue spindle motor: 1/3 HP, gear-driven
End trim motor: 1/4 HP, belt-driven
Flush trim motor: 3/4 HP, belt-driven
Buffing motor: 1/4 HP, direct-drive
Each motor is single-phase, capacitor-start induction type, with shielded, permanently sealed bearings for low maintenance.
What are the electrical requirements?
Power requirement: 220V, Single-Phase, 60 Hz
Full-load current rating: 19A
Minimum circuit size: 30A
Plug type: NEMA L6-30
Power cord included: Yes (12 AWG)
Does the G0774 require air supply?
Yes. The pneumatic system requires 6 SCFM @ 100 PSI. A built-in air regulator and filter are included for reliable performance.
What dust collection is needed?
The G0774 includes two 4" dust ports. A dust collection system capable of at least 700 CFM is required for proper operation.
What are the table and construction details?
Work table length: 78-3/4"
Work table width: 10-1/2"
Construction: Steel frame with aluminum housing and powder-coated finish
Rollers: Industrial-duty rubber rollers with adjustable table rollers
What special features does the G0774 include?
Automatic belt feed with adjustable table rollers
Heated infeed fence for better glue dispersion
Pneumatic edgebanding guillotine
Double-bladed end-trimming saw
Upper and lower trimming units with digital readout
Upper and lower buffing units
Extendable side bar for larger panels
Control panel with individual controls for each function
31-1/2" tape coil support
How loud is the G0774 during operation?
The G0774 has a sound rating of approximately 80 dB, similar to the noise level of a shop vacuum.
How long does setup take?
Assembly and setup take approximately 2 hours.
Where is the G0774 manufactured?
The G0774 is made in Taiwan at an ISO 9001-certified factory.