Quick Reference Specifications
| Category | Detail |
|---|---|
| Power | 120V or 240V, Single-Phase, 60 Hz |
| Current | 15A (120V), 7.5A (240V) |
| Circuit | 20A (120V), 15A (240V) |
| Motor | 2 HP, TEFC Induction, 3450 RPM |
| Arbor Size | 5/8 in. |
| Max Dado Width | 13/16 in. |
| Blade Tilt | Left, up to 45° |
| Max Cut Depth | 3-1/4" at 90°, 2-1/4" at 45° |
| Table Size (with wings) | 40-1/2" W x 27" D |
| Floor to Table Height | 35-3/8 in. |
Power & Electrical
- Can this saw run on 240 volts?
Yes. The G0771Z can operate on 120V or 240V and is prewired for 120V when shipped. Specs:- Full-load current: 15A at 120V, 7.5A at 240V
- Minimum circuit: 20A at 120V, 15A at 240V
- Plug: 5-15 (120V) included; 6-15 (240V) recommended
- Is a 240V conversion kit needed?
No kit is required, but you will need:- A 6-15 plug (available at most hardware stores)
- P0771Z029V4-11X Circuit Breaker to replace the factory-installed breaker
- Adjust the motor wiring per instructions on page 14 of the manual
- Does the G0771Z require a 20-amp circuit breaker?
Yes. It requires a 20A circuit for operation on 110V. - Does the saw have the same power on 110V and 220V?
Yes, the available power is the same, but 220V operation is more efficient and uses less power overall. - What is the power factor for the motor?
The manufacturer did not provide a power factor for this model.
Compatibility & Accessories
- Can I add a router table top to this saw?
Yes. You can add the H7507 Router Table. - Which fence system upgrade do you recommend?
The W2005 Fence is the recommended upgrade. - Is there a table extension available?
Yes. The T34287 Extension Table Kit is available as an accessory. - Is there a sliding table compatible with this saw?
Yes. The T32737 Sliding Crosscut Table Attachment is compatible.
Cutting Capacity & Features
- Does it have a left-tilt arbor?
Yes. The blade tilts to the left. - Can this saw handle a dado setup?
Yes. The G0771Z accepts a dado blade set. Maximum dado width is 13/16 inch. - What is the arbor length?
The arbor supports a maximum dado width of 13/16 inch. - Does the G0771Z come with a riving knife?
Yes. It includes a riving knife.
Dust Collection
- Can the dust collector fitting be mounted on the left side?
No. The left side does not have a cutout for the dust port.