General Specifications & Features

Q: Which mobile base is compatible with the G0513Z?
A: The T28000 Mobile Base is recommended. D2057A, T31566, and T33447 are also compatible.

Q: What are the differences between the G0513Z and G0513 models?
A: The G0513Z has a maximum cutting width of 16-1/8", while the G0513 offers 16-1/4". The G0513Z also features a cast iron fence with an extruded aluminum resaw fence, whereas the G0513 has an aluminum fence.

Q: What is the resaw capacity of the G0513Z?
A: The resaw capacity is 12-1/8 inches.

Q: Are the wheels cast iron or aluminum?
A: The wheels are computer-balanced cast aluminum.

Q: Is a blade included with the saw?
A: Yes, it comes equipped with a 131-1/2", 1/2", 6 TPI hook blade.

Q: What is the black bar in the middle of the fence? Can it be removed?
A: That is a resaw drift bar, which helps control blade drift during resawing. It can be removed if needed for straight cuts.

Electrical & Power

Q: What is the operating voltage and current?
A: The saw operates on 110V or 220V:

• At 110V, it draws 20A
• At 220V, it draws 10A
  It ships prewired for 220V.

Q: Can it run on a regular 110V outlet?
A: Yes, it can be converted to 110V operation by changing the plug and rewiring the motor.

Q: Will it operate on a 240V outlet?
A: Yes, 240V is within the acceptable range for this machine.

Q: How do I switch to 110V from 220V?
A: You’ll need to change the plug and rewire the motor. Contact Product Support for guidance.

Q: What kind of power cord and plug does it use?
A: It includes a 72" cord but no plug. Recommended plugs:

• L5-30 for 110V
• 6-15 for 220V

Setup & Assembly

Q: How long does assembly take and how many people are needed?
A: Assembly takes about one hour and is easier with two people, especially when lifting the machine and installing the table.

Q: Does the saw ship upright or laying down?
A: The saw ships upright and must remain upright during transport.

Performance & Use

Q: Is this a good choice for ripping 2x6s into 3/8" thick pieces?
A: Yes, the G0513Z is well-suited for resawing tasks like this. Blade kerf (cut width) will vary depending on the blade used, but typically ranges from 1/32" to 1/16".

Q: What resaw fence options are available for the G0640X?
A: The G0640X includes an extruded aluminum resaw fence. For drift bar compatibility:

• Use T1194 (pre-drilled for drift bar)
• Or drill your existing fence to install T1213 drift bar separately

Q: Can I upgrade the motor to 3 HP?
A: No upgrade is available for this model. However, Grizzly offers other bandsaws with 3 HP motors. Visit the Bandsaws section on Grizzly.com and sort by horsepower.

Q: I just got this bandsaw and the blade guide cover bangs against the machine. How do I fix it?
A: Check and tighten:

• Bolt #199 (secures the assembly)
• Bolt #136 (secures the sliding block)
  Refer to page 82 of the parts manual and page 46 for illustrations.