General Specifications & Features
Q: Does the G0962A40 have a discharge system for sawdust?
A: Yes. It features a 4" dust port that can be connected to a dust collection system.
Q: Which way does the blade tilt?
A: The blade tilts to the left.
Q: Is this saw belt-driven?
A: Yes. The G0962 is a belt-driven table saw.
Q: Are the trunnions mounted to the table or the base?
A: The trunnions are mounted to the cabinet base.
Q: Does the rip fence lock on both the front and rear rails?
A: No. The fence locks only to the front rail.
Q: What is the total width of the saw with both side extensions?
A: The saw measures 64" side-to-side and 40-1/2" front-to-back.
Q: What is the stand height before attaching the saw table?
A: The cabinet height is 34-1/2" without the saw top.
Q: What is the height of the roller base when detached?
A: From the floor to the bottom of the swivel is 3-3/4".
Electrical & Power
Q: Can this saw run on 15A?
A: Electrical specs:
- Full-Load Current: 15A at 120V, 7.5A at 240V
- Minimum Circuit Size: 20A at 120V, 15A at 240V
Q: Will this saw run off a generator?
A: No. The magnetic switch is not compatible with generator voltage output and may not stay engaged.
Q: Do you sell a 240V conversion kit? Will it run on 240V single-phase?
A: Yes, it will run on 240V single-phase. While there’s no official kit, you can purchase:
- PX1837312X Switch
- PX1837357X Power Cord
- P0771Z029V4-11X Circuit Breaker
Refer to the manual or consult an electrician for installation.
Cutting Capabilities
Q: Can this saw handle a dado blade?
A: Yes. It includes a dado table insert and supports:
- Maximum dado blade diameter: 8"
- Maximum cutting width: 13/16"
Packaging & Installation
Q: How is it packaged for shipment?
A: The saw ships in two cardboard boxes:
- Box 1: 40" x 30" x 29" (259 lbs)
- Box 2: 66" x 16" x 6" (38 lbs)
Q: The spec sheet shows box #1 as 40" wide. My door is 26" wide. What is the minimum width once unpackaged?
A: The base footprint is 21" x 19-1/2". If you remove the table, it will fit through a 26" door.
Q: Can the rail system be removed to reduce the overall width?
A: No. The fence mounts to the rail system, so removing it would make the fence unusable. Modifications are not recommended.
Accessories & Compatibility
Q: I don’t like the grooves in the fence. Are other fences compatible?
A: The stock fence is custom and not easily replaceable. However, you can mount a flat board over the grooves. Compatible systems include:
- W2005
- W2006
- W1716
- W1720
Other Questions
Q: Do Grizzly saws have flesh-sensing technology?
A: No. The G0962 does not include SawStop-style safety features, as that technology is proprietary to SawStop.
Q: Do I pay freight if I pick up in store?
A: No. Freight fees do not apply to showroom pickups.